- Glass Cleaner
- Vinyl Contact
- Craft Knife or Razor Knife
- Glass Object to Etch
- Glass Etching Cream
- Paintbrush
- Carbon Paper or a Stencil
Steps for How to Create Your Own Glass Etching Design
- Wash the glass object with the glass cleaner.
- Completely dry the glass object.
- Cut a piece of vinyl contact bigger than the size of the pattern you wish to etch.
- Firmly press the vinyl contact on the glass object making sure the vinyl contact is perfectly smooth.
- Reapply the vinyl contact paper if there are air bubbles underneath.
- Place the carbon paper on the vinyl contact.
- If you are using a picture to trace, place it on the carbon paper.
- Draw or trace the design.
- Cut the design out using a craft or razor knife.
- Peel off the sections of the vinyl where you want the glass to be etched.
- Apply the etching cream as evenly as possible over the exposed areas of the glass with a paintbrush.
- Leave the etching cream on for the amount of time suggested on the label.
- Rinse the etching cream off with clean water.
- Remove the vinyl contact.
- Clean the glass object with glass cleaner.